Linux不完全攻略

2.2.2 設備OK，準備上網

2.2.2.1 路由方式

如果你通過局域網中的路由器或充當路由器的計算機上網，請把網關設置為那臺路由器的IP地址。重新啟動網絡部分，或者下次開機，你已經在網上。

2.2.2.2 撥號

如果你用電話撥號、ISDN、xDSL或以太網虛擬撥號方式上網，請用“開始”菜單->“網絡”->“撥號程序”創建連接。這個撥號程序是“中關村百校信息園”出的，各步驟都有中文提示。

2.2.2.3 開機直接撥號

如果你用LAN虛擬撥號/xDSL方式上網，用月租方式而不以分鐘、小時計時，你可以將撥號程序設置為開機期間一直在線。

以“root”身份登錄系統，打開“終端”，執行“adsl-setup”。過程中屏幕顯示、注釋和用戶輸入如下，其中帶“[]”的項由你輸入，由“#”開頭的行為我添加的注釋。

#里面的英文都不難。因?yàn)槲业倪B接已經配置好，下面的顯示可能與第一次配置有所不同。但也不會相差多少。

Welcome to the ADSL client setup. First, I will run some checks on

your system to make sure the PPPoE client is installed properly...

The following DSL config was found on your system:

Device: Name:

ppp0 DSLppp0

Please enter the device if you want to configure the present DSL config

(default ppp0) or enter ´n´ if you want to create a new one: [ppp0]

#歡迎使用ADSL客戶端設置程序……

#……

#請輸入你想創建的撥號設備名(默認是ppp0)或輸入“n”新創建一個設備：

LOGIN NAME

Enter your Login Name: [你從電信申請的用戶名]

#帳號/登錄名

#在這里輸入你的帳號/登錄名：

INTERFACE

Enter the Ethernet interface connected to the ADSL modem

For Solaris, this is likely to be something like /dev/hme0.

For Linux, it will be ethX, where ´X´ is a number.

(default eth0): [eth0]

#界面

#輸入連接到ADSL調制解調器的以太網界面。用以太網虛擬撥號的同樣適用。

#對于Soliris，可能是類似/dev/hme0的東西。

#對于Linux，是ethX，X是一個整數。

#(默認是eth0)：

#eth0一般紙Linux下第一以太網卡。第二塊網卡eth1……第N+1塊網卡ethN。

Do you want the link to come up on demand, or stay up continuously?

If you want it to come up on demand, enter the idle time in seconds

after which the link should be dropped. If you want the link to

stay up permanently, enter ´no´ (two letters, lower-case.)

NOTE: Demand-activated links do not interact well with dynamic IP

addresses. You may have some problems with demand-activated links.

Enter the demand value (default no): [no]

#是否要啟動一個動態連接守護進程?(默認不啟動)

DNS

Please enter the IP address of your ISP´s primary DNS server.

If your ISP claims that ´the server will provide dynamic DNS addresses´,

enter ´server´ (all lower-case) here.

If you just press enter, I will assume you know what you are

doing and not modify your DNS setup.

Enter the DNS information here: []

#域名服務器

#請輸入域名服務器的IP。

#什么都不輸表示使用電信公司默認的域名服務器。